HT-1 Bright LED

Discussion - HT-1 amplifiers
Post Reply
Posts: 1
Joined: Tue Dec 27, 2016 6:02 pm

Tue Dec 27, 2016 6:21 pm

Every time I bent over my HT-1R, I burned my retinas because the power LED is way too bright. With what was left of my eyesight, I found R81 (near the center of the circuit board) is the current limiting resistor for the LED and is 1k. I replaced it with a 47k and that dimmed the LED acceptably. Additionally, I carefully sanded the LED and filed the top so it is more diffuse.

Since R81 is a surface mount resistor, don't try this mod unless you are good at soldering.

It will also void your warranty.

User avatar
Posts: 205
Joined: Sun Apr 13, 2014 2:53 pm

Wed Dec 28, 2016 10:38 am

Thanks for the tip but I'm unable to perform the mod as I went blind from glancing at the LED a few months ago.

Post Reply
  • Information
  • Who is online

    Users browsing this forum: No registered users and 27 guests