Weird I Know but I am reading the Manual regarding the advanced features!......
Your ID:Core amplifier has further advanced features which are aimed at more in-
depth users who enjoy getting the most from their amplifier. These features do
not have independent controls on the front panel of the amplifier, but instead are
accessed by using the Tap switch (14) as a ‘shift key’ and using other controls to
access these features.
Tap + Bass
The Resonance control sets the overall bass response. At lower settings the cleans
will be tight and funky and overdrives will be focused in their bass response. At
increased settings the clean sounds will be become full and warm, whilst the crunch
and overdrive tones will be more bass heavy and resonant"
This sounds interesting but does anyone know if these settings are stored on the amp when you switch it off? Also if they are stored are they stored patch by patch or just as a general patch wide amp setting?
I am assuming there is no visual representation on the Insider software that you have tweaked these settings?
Discussion - ID:Core, ID:Core V2 and ID:Core 100/150 amplifiers.
2 posts • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 3 guests