Blackstar with select-able cab schematic
I want to use my HT5 for recordings at home and want to be able to switch between
different cabs (with 1x 16 Ohm Celestion speakers).
I think I need to put a 16 Ohm resistor as a dummy load because there will be short period with no speaker
attached to the amp when switching....
is this correct? do I need more specs/things to consider?
and will the switch work as drawn? with the plus switching and the v- permanently connected with the - of both speakers?
Upload your pictures here
2 posts • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 3 guests