Channel switch between OD2 and Clean using FX board mono jack amp control

Discussion - HT Venue and HT Venue MkII amplifiers. Inspiration from Studio to Stage. The Valve Amp Redefined.
Post Reply
davebees
Posts: 1
Joined: Tue Jun 05, 2018 9:48 pm

Wed Jun 06, 2018 10:16 am

Please help. I want to channel switch between OD2 and Clean on a Blackstar Stage 60 Mk1 using the mono jack amp control from a GT10.

I've plugged one end of the 9 pin cable into the amp an shorted out the pins that would do it and it switches between these 2 channels fine but there are 3 pins involved and the mono jack amp control is just open or closed circuit (two pin). If someone knows how to connect the 3 pins from the cable to the 2 pins of the mono jack to make it work that would be great. Maybe I need a relay or something but I think they need power- Hmmm!!

Fingers crossed!!

Post Reply
  • Information
  • Who is online

    Users browsing this forum: No registered users and 7 guests