Loose Power Socket

Discussion - HT-1 amplifiers
Post Reply
Posts: 1
Joined: Tue Nov 22, 2011 1:00 am
Location: Australia

Tue Nov 22, 2011 11:59 am

Hey guys,

I Picked up a HT-1R a couple weeks ago and I'm loving the crap out of it, I just have one little issue. The socket for the 240v power cable is kinda loose, I would say it has at least a few mm of "wiggle" either side as well as up and down.

Any way my question is whether this is something common to the HT-1s or if I should be concerned about the socket breaking.

Thanks in advance!

Posts: 16
Joined: Thu Nov 28, 2013 5:08 pm

Thu Nov 28, 2013 6:30 pm


I just bought an HT-1R and it sounds great. I have this same issue, though, and was wondering if anyone else has noticed this? I just want to make sure it is not going to be a problem in the long run.

I have also noticed the gain/volume increasing substantially once the gain knob hits 12:00-1:00 (as reported in other threads). I assume this is normal behavior too?


Post Reply
  • Information
  • Who is online

    Users browsing this forum: No registered users and 18 guests